Note: click on a thumbnail for a BIG version (1600x1200)
Case:
 These are the ventilation holes I drilled in the case. I drilled these without a grid, and it shows. Look at the other pic for the results I got w/a grid.
|
 This is the case before I cut out its guts. I bought a couple of extras because I actually found it useful for holding some of my junk.
|
 The holes on the near side were drilled with a grid I printed on a big sticker (from my CD Stomper).
|
 Here is the case during vivisection. Not a pretty site. It took away all my delusions about doing a similar surgery on myself with power tools
|
My Car: (note the lack of exterior shots....it's ugly)
 This is what I look at while i drive (besides the road). The highest the middle one has ever been is around 115.
|
 The inside of the car. Don't ask about the baseball bat.
|
 This is a razor sharp shot of the shift knob. Unfortunately, my intent was for the radio to be in focus. Note the cutout just above the termometer. That is where the LCD will go.
|
 This is the key. I needed a fourth picture to round out this table. If you ever wanted to know everything about the key, this is your chance.
|
Misc:
 This is my parts bin. Some old 486s and misc junk. Also note my 65ft crossover cable.
|
 Another board I had, but decided not to use
|
 This is the player in the old case, which had the same dimensions, but 1/4" less height. The floppy drive is not normally hooked up.
|
|
